Multiecuscan

Hello - Would it be possible to add functionality to MES to lower the active aero front splitter on the Quadrifoglio version of the Giulia? Maybe also add a calibration routine for the motors. Just having the ability to lower it would be nice though.

Best regards

Good morning,

I see that version 4.7 of MES adds some functionality for Active aerodynamic modules left and right. Is this for the front splitter? I gave this a shot a few times and kept receiving an error that a connection cannot be established with the module. I'm using a ELM 327 compatible cable along with the blue adapter and confirmed it works by connecting to other modules using the same cable combo. I have a 2018 Giulia QV in North America. I submitted a report from MES also. Not sure what data that provides you.

20/11/2020 - Multiecuscan 4.7

- Support for Active aerodynamic module LEFT (AAML) (Giulia, Stelvio)
- Support for Active aerodynamic module RIGHT (AAMR) (Giulia, Stelvio)

I'm having the same problem with Multiplex MES 4.7

Same issue here too with Mes 4.7 Multiplex. It is not connecting to either Splitter modules at all. @yani what's the fix?? I am also not able to read IBS data on my 2019 Quadrifoglio where as I was able to read it in 2017 2.0ncar I had before this.