Multiecuscan

Hi,

I used the Multiecuscan today, for the 1st time (Version 2.1 demo) on Lancia Lybra 1.8 (pre-EOBD, made 12/1999, Hitachi MPI). I had some disconnections when runs some engine parametres and many diconnection when plot a graph, and I need to connect ECU again all the time. The ABS & Aibag section works very well.

Is this a bug with this Hitachi version or it is usual on demo multiecuscan version?

Keep your good works...

What interface are you using? Try the ELM327, it's much better than the KKL VAG-COM type.

did you noticed any latency warnings?
you can see it on the bottom left corner of the software.

maybe is it.