Alfa 159 Cruise Control Retrofit - Not Detected
Posted: 27 Feb 2020, 16:59
Hello,
I retrofitted cruise control on my Alfa Romeo 159, 2008, 1.9 JTDm 16v (the wire look was already there so it was easy to just plug in), however it does not detect it. The buttons do nothing. I've turned the car off multiple times, disconnected the battery and tested at higher speeds - it doesn't work.
In MES, I ran a proxi alignment and upon connection it said "It is configured correctly, alignment is not needed.", so in the proxy settings I enabled the Cruise Control Light, because that's the only thing related to cruise control, and then I ran a proxi alignment which was Successful. Then in Engine > ECU I ran the self-learn function and that was also Successful. It didn't work again. No light. No functionality. Nothing.
I've read on forums that other people have managed to do this easily, some have not.
In MES, when looking at the parameters for Cruise Control values - it is blank. Not detecting any values.
Does anyone know what I need to do to get it to work?
I retrofitted cruise control on my Alfa Romeo 159, 2008, 1.9 JTDm 16v (the wire look was already there so it was easy to just plug in), however it does not detect it. The buttons do nothing. I've turned the car off multiple times, disconnected the battery and tested at higher speeds - it doesn't work.
In MES, I ran a proxi alignment and upon connection it said "It is configured correctly, alignment is not needed.", so in the proxy settings I enabled the Cruise Control Light, because that's the only thing related to cruise control, and then I ran a proxi alignment which was Successful. Then in Engine > ECU I ran the self-learn function and that was also Successful. It didn't work again. No light. No functionality. Nothing.
I've read on forums that other people have managed to do this easily, some have not.
In MES, when looking at the parameters for Cruise Control values - it is blank. Not detecting any values.
Does anyone know what I need to do to get it to work?
