Multiecuscan

Hi Yani!

Thanks for your great software, and your support. i have tried the "free" version and i cleared the engine error, but saw only a few test and options and i would like to get the FULL version, could you tell me how i do? My e-mail "dbc_2k2@hotmail.com".

By the way, i have one question about the connector and the "Vag-com". I get the switch hack into the interface, and i can switch between the 1, 3, 7, 9 pin's BUT... seeing the connector diagram i think i could switch too the 12 & 13 pin's too:



pin 12 (engine compartment cable), and 13 (rear cable). I will "re-switch" it to add this 2 new pins to the switch.

And one last (really) question on this post hehe, could you add a "Service Reset" to "Punto 03 1.9 JTD"? That's my car .

THANKS Yani

Yani please, would it be kind of woth?

Please...

I don't understand! This question seems to be from 2010.
Punto '03 JTD is supported from long ago. Also, we have a description about pin 12 from long ago.
Pin 13 is not used at the moment in Multiecuscan. There are a few Fiat ECUs which are connected to pin 13, but these are not supported by Multiecuscan yet.