ME3.1 EODB
Posted: 08 Apr 2010, 11:03
yani,, when is this ecu going to be supported regards dave
Page 1 of 1
Re: ME3.1 EODB
Posted: 14 Apr 2010, 11:54
im just curious ,whats the point of posting a question on this forum, and not receiving reply or acknowledgement ,never mind an answer
Re: ME3.1 EODB
Posted: 15 Apr 2010, 07:39
It will be supported soon.
Meanwhile you can try to connect to your car using supported definition М7.3.1
Meanwhile you can try to connect to your car using supported definition М7.3.1
Re: ME3.1 EODB
Posted: 28 Apr 2010, 22:28
pr_00f wrote:It will be supported soon.
Meanwhile you can try to connect to your car using supported definition М7.3.1
i have already checked that out and values are somewhat distorted ,so i wouldnt so much trust error codes
Re: ME3.1 EODB
Posted: 29 Apr 2010, 04:59
It is already added to version 2.2. You just have to wait for me to release the next version.
Yani
Yani
Re: ME3.1 EODB
Posted: 12 May 2010, 17:18
wont connect on 2.2 no errors but i can connect on 7.3.1 no problem read fault codes and run actuators etc ,
is there a fault/error with this latest software?????
is there a fault/error with this latest software?????