Connection with Fiat DOblo
Posted: 07 Apr 2010, 13:01
Hello everybody,
I have a Fiat Doblo Multijet 105CV (2007). I tried to make a connection but no reaction from multiecuscan software !!!!
My problem : after few trials, I was able to find the good parameters with my ELM327 interface : EDC16 ECU and rate bauds 9600 bauds.
With these 2 options, the LEDs of the ELM327 interface reacted (with others adjustements : no reaction) but I'm not connected. The message "connecting" disapeared but no connection !!!!
Is-it a problem of interface or may be I'm not use the software well ?
Thanks.
I have a Fiat Doblo Multijet 105CV (2007). I tried to make a connection but no reaction from multiecuscan software !!!!
My problem : after few trials, I was able to find the good parameters with my ELM327 interface : EDC16 ECU and rate bauds 9600 bauds.
With these 2 options, the LEDs of the ELM327 interface reacted (with others adjustements : no reaction) but I'm not connected. The message "connecting" disapeared but no connection !!!!
Is-it a problem of interface or may be I'm not use the software well ?
Thanks.