Multiecuscan

Posted: **12 Sep 2018, 13:38**

Hi all,

I'm trying to connect with my Fiat Grande Punto T-Jet (2008) in order to activate cruise control. However, i can't connect to the car. All the COM ports are fully functional but i still get the message "Failed to connect to Body Computer" when i try to connect. What am i doing wrong?

-ELM327
-Multiecuscan 4.2 REGISTERED

Thanks in advance,

ThreshNL

Posted: **26 Nov 2018, 17:41**

ThreshNL wrote: ↑12 Sep 2018, 13:38 Hi all,

I'm trying to connect with my Fiat Grande Punto T-Jet (2008) in order to activate cruise control. However, i can't connect to the car. All the COM ports are fully functional but i still get the message "Failed to connect to Body Computer" when i try to connect. What am i doing wrong?

-ELM327
-Multiecuscan 4.2 REGISTERED

Thanks in advance,

ThreshNL

Take a look right here...

http://forum.multiecuscan.net/viewtopic.php?f=5&t=1493

Good luck! (I'm trying to connect too)

Posted: **21 Jan 2019, 20:54**

Usually if you can connect to the engine but not other modules, than your ELM has bad termination resistor on CAN line. After removing (and even better: adding proper termination), it should work.

Only if you have FTDI USB IC in it and PIC microcontroller.
Cheap fake chinese clones are totally useless.

Multiecuscan

Failed to connect to Body Computer

Failed to connect to Body Computer

Re: Failed to connect to Body Computer

Re: Failed to connect to Body Computer