Multiecuscan

Hello I am your forum member - FRebelo from Portugal i have a 2010 500c Abarth.
Last week I bought a used TFT cluster from a 500 (2015) to swap for my analogue one.

Houp you can help me.
I bought the used TFT cluster with 2720km
I have bought the 4.1 multiecuscan register pack.
And a modified ELM327 with a yellow, green, purple and red cable.
I have done the correction of the Km to my real km on the standard cluster (74620) and it stop flashing.
I have done a proxy alignment to 60 code Configuration (abarth) And I have the abarth theme on the TFT like I wanted. 

But I still have 4 problems. 

1- I still have the clock flashing 
2- I don't have access to language,date,time on the tft
3- I don't have any information about blue&me on the tft cluster 
4- my blue&me buttons on the steering wheel alow me to access voice control, but I don't have information on the tft cluster to pair other phones or access phone book.

Can you tel me if I am making any mastake on the conversion from the analogue cluster to the TFT one.

Your forum member - FRebelo

My best regards hoping you canhelp me. 

Ps - i have made a vídeo to alow you to se what i say.

vídeo - https://www.youtube.com/watch?v=TuexwtK8liM

Functions that you are missing, are in the new radio, which occurs with the tft counter, so they are not in the meter, and will not work The counter is blinking, because the system does not provide tft configuration with the old radio. A short series of cars with tft and old radio, wrong in such cars proxi was set up manually, and rather with hard it will be done in your conditions.
Regards

Have you find a way to adjust these options?

Try to send a report from proxi to Yani, maybe it will take care of it, because there are more and more such modifications. I suspect that changing the counter of one byte will solve the problem only Yani, would have to check which one?
This is possible because cars with this configuration were produced