[Help] Failed to perform Proxi Alignement
Posted: 14 Jun 2018, 13:47
Hi there,
today i've tried using multiecuscan 4.0 to perform proxi alignment on jeep renegade 2.0 multijet.
something gone wrong and i know why, in the mid of alignement ecuscan asked me to change cable interface adaptors, i didn't change it and now, when i try to connect on the body alignement, 4 modules are gone (EOL Error).
if i get back this 2 adaptors (A5 and A6) and i will perform again proxi alignement, it would be Ok? i've lost something for my mistake? i have to do anything else?
Thanks for the support,
M.
today i've tried using multiecuscan 4.0 to perform proxi alignment on jeep renegade 2.0 multijet.
something gone wrong and i know why, in the mid of alignement ecuscan asked me to change cable interface adaptors, i didn't change it and now, when i try to connect on the body alignement, 4 modules are gone (EOL Error).
if i get back this 2 adaptors (A5 and A6) and i will perform again proxi alignement, it would be Ok? i've lost something for my mistake? i have to do anything else?
Thanks for the support,
M.