MES proxy problem
Posted: 27 Feb 2018, 23:23
Good evening guys, I have a problem with MULTIECUSCAN. If I click CTRL + ALT + C in the "CAN Setup / PROXI Alignement Procedure> Adaptation" window, nothing comes out of it, I have Multiecuscan registered.
Last week I contacted "obdspecialist" from whom I bought both the ELM 327 interface and the MULTIECUSCAN software, when I exposed the problem, they replied that the problem was due to the type of Windows.
I tested both with Windows 7 and with Windows Starter, but the CTRL + ALT + C window does not open.
I would like to activate the sport button on my 1.6 mjet delta launcher.
Can anyone help me?
Thanks so much. Peter
Last week I contacted "obdspecialist" from whom I bought both the ELM 327 interface and the MULTIECUSCAN software, when I exposed the problem, they replied that the problem was due to the type of Windows.
I tested both with Windows 7 and with Windows Starter, but the CTRL + ALT + C window does not open.
I would like to activate the sport button on my 1.6 mjet delta launcher.
Can anyone help me?
Thanks so much. Peter