Page 1 of 1
ISO invalid jeep renegade 1.4 multiair
Posted: 02 Nov 2016, 13:33
by stormrider
Hi there, i have this error ,i try do learn the neutral ,(gearbox) and now i have an warning message on the dashboard and cannot erase this error , or this version of multiecuscan (3.3) is not for the turbo 1.4 l multiair ??
thx
Of course i have a licence
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 08 Nov 2016, 18:53
by stormrider
no one here ???
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 09 Nov 2016, 12:04
by stormrider
up
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 09 Nov 2016, 12:46
by s130
Suggest you Email Support directly for this. Also in preparation grab a copy of the MES log file.
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 09 Nov 2016, 14:39
by stormrider
when i try do learn tje neutral (for s&s) there is a error message , erreur d'execution ,in french
and now i have the mileage motor always on
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 17 Nov 2016, 13:51
by stormrider
fix it
thx yani
Re: ISO invalid jeep renegade 1.4 multiair
Posted: 17 Nov 2016, 14:03
by stormrider
Please try the following sequence:
1. vehicle stationary, clutch not pressed, gear in Neutral
2. Execute the "Neutral signal learn" procedure
3. wait 2-3 seconds
4. press clutch and insert first gear
5. wait 2-3 seconds
The procedure should complete correctly after this.