Multiecuscan

Hi Yani,
I notice in Fiat Examiner there is a option: "Ignore ISO Codes"
I think, if one can ignore the ISO codes, one can access more control units with the same communications procedures.
It may be worthwhile to look into that for your new version.
Thanks, you have been doing a fantastic job so far!
Regards,
Dev

You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani

Oops, have not seen that yet. Sorry!
Regards, Dev

yani wrote:You CAN ignore ISO codes. Just press Y when the program shows the mesage "Invalid ISO Code! Press Y To Continue or Press N To Abort".

Yani

I pressed Y, but I coucn't see values of parameters