Page 1 of 1
connection freemont 2.0multijet
Posted: 20 Jan 2015, 15:35
by frodus
When i connect to car with the free version program will write "free version restriction"
Need I full version to connect engine ?!?
Thanks
Re: connection freemont 2.0multijet
Posted: 21 Jan 2015, 11:02
by Waltomatic
Re: connection freemont 2.0multijet
Posted: 21 Jan 2015, 19:48
by frodus
dakujem pekne
but I did not notice it
Re: connection freemont 2.0multijet
Posted: 21 Jan 2015, 22:18
by Waltomatic
frodus wrote:
dakujem pekne
??????
but I did not notice it
Acording this page: PLEASE NOTE: The modules in red are NOT supported by the FREE version! You can connect to these modules with the FREE version, but after successful connection the program will only show the Info screen and the following message: FREE VERSION RESTRICTION / This module requires REGISTERED version! / You can run it in 'simulation' (CTRL+F10) mode only!
If the connection is not successful then you will see another message.
Re: connection freemont 2.0multijet
Posted: 22 Jan 2015, 08:10
by us911
dakujem pekne = thank you
Re: connection freemont 2.0multijet
Posted: 22 Jan 2015, 11:35
by Waltomatic
de nada...
