Multiecuscan

Been trying to set the proxy alingment for cruise light, no success. Cruise after mark fitted, works fine but without light on dash. We hawe registed multiecuscan and modified elm 327, one resistor remowed. Acces to body computer after resistor removing, and through BC can we go to change cruise light from disabled to enbled, it works- but doesent stay that way, why? I we been doing like info there says, execute after enabling and trying it several times, pressed yes etc and gone away from bodycomputer- but light doesent work and if go bact to BC and look again cruiselight status- it is again disabled. Cruise works as it has to, go off when brake or glutch is pressed, brake lights works fine all that ok.

I could chec by actuator that light in instrument panel is ok. One fault was B100D and got rid of it. Allso body computer had faults B1029 and U1602 an got remowed as well.

Why this cruiselight doesent stay enabled there ?

edit. today tried with another interface, but same thing happends. I checked the "simulate" part to make shure for doing right and notised little difference. I hawe in simulate mode "in progress" /completed " message when change is done, but dont get that in real when I try to make change to real proxy alingment. And when i go to body computer in, elm indicator lights flashes- so it make contact to BC, and can reset error code what there was, but when i make that disable to enable change for cruiselight those indicator light doesent flash at all. So i tryed to make some others changes just for try- not success as well. For some reason- data is not moving then when changes is made. WHY ?
I can allso see "disconnect" text in left low corner, dont know what that means- connection seenms to be ok anyway becouse error codes can be remowed.

I hope you are doing the procedure until the end.
That means turn off the key after procedure (or take it put from lock).
Wait some time (wait around one minute) and then check again.

And here are some information about PROXY procedure.
In my case 99% of them fail on "dash mode" and only 1% have complete success.
I tested with CanTieCar interface and OBD protect interface and result is the same.

Hello. I can help you. Today I turned on the light and Reporting on the cruis control the display of fiat stylus. After you put enabled cruis control lamp on multiecuscan, you must select the top item from the list or array proxy. No other item must be selected in the menu after which will start the write operation proxy and that's it. I also had the same problem and then I solved was simple. Works & 100%. If you have problems even write me in private