Multiecuscan

hello to the community

just bought a kkl vag com cable for 409.1 version.

installed the drivers set up the com ports correctly and install multiecuscan
run the config and set up there aswell the correst com ports

but i still cant connect to ecu on my alfa brera tbi

any help would be gratefull

thanks in advance

Hello

Go to Settings MES / Interfaces
and press next to the notified interface the "Test" button

And put the screenshot on here a

As you can see possibly if there is an error

Which driver was installed?
Where is the driver from?


Greetings Eddy

My VAG only works in MES if I set it in TWO COM ports: the real installed on Windows and a second "COM3" that MES sees beyond the real.

When i press the test button it seems to pass the 1000ms latency test aswell as the 200ms test and then i get an error at 750ms test
Also tryied to a different usb on my laptop (changed the com ports too)

Btw im using win 7 x64

The drivers are the one came with the cable ( i will post them as soon as i get home)
Should i go with different driver?

automatos wrote:When i press the test button it seems to pass the 1000ms latency test aswell as the 200ms test and then i get an error at 750ms test
Also tryied to a different usb on my laptop (changed the com ports too)

Btw im using win 7 x64

The drivers are the one came with the cable ( i will post them as soon as i get home)
Should i go with different driver?

And how many interfaces MES found at Scan Interfaces?

automatos wrote:When i press the test button it seems to pass the 1000ms latency test aswell as the 200ms test and then i get an error at 750ms test
Also tryied to a different usb on my laptop (changed the com ports too)

Btw im using win 7 x64

The drivers are the one came with the cable ( i will post them as soon as i get home)
Should i go with different driver?

- do you have ELM 327?
Sometimes on newer cars just like your Brera is, it is easier to connect with ELM on engine ECU.
- for frivers you need FTDI drivers (http://www.ftdichip.com/Drivers/VCP.htm) and NET framework 4.

I'm using only Framework 2.0 for ELM or VAG.