Multiecuscan

Hi guys,


I've Multiecuscan 2.1, when i scan my car can see only engine, gearbox and CAN network. Cannot see ABS and Airbag modules.
My ELM327 was modified according viewtopic.php?f=5&t=1493 , now i see CAN network
I would like to communicate with all modules, even if the module have a "Invalid ISO Code".
I have the adapter green, red and yellow too. I try with KKL too.
My vehicle is Brazilian and is not present in the list of models supported by Multiecuscan.
The modules are shared between various models of vehicles, so I can connect to recognized modules selecting other models of vehicles.


My car is a: Fiat Palio Essence 1.6 16V E-torq Dualogic 2010.

Engine is -> IAW7GF (I can connect this module selecting: Idea 1.6 16V, but with the message "Invalid ISO code" )
Gearbox is -> CFC319 (I can connect this module selecting: Punto Intern. 1.6 16V, ISO code is Valid ). This is new in version 2.1 and it works fine.
CAN network is -> Instrument Panel Marelli and Body Computer Marelli (2) (I can connect this modules selecting any Fiat model that have these systems, ISO code is Valid )

I wish the Multiecuscan could see modules Airbag Abs and I try to connect by selecting some Fiat model that has the same system.


Can anyone help me?
Is it problem with cables or Multiecuscan really will not be able to connect to my vehicle due to lack of compatibility?


Sorry for bad english. I used google to translate everything


Thanks

Caro Nariz! (Dear Nose), hehehe

If you click Scan Modules option (with and without adapters), which MES found?

Abraço!

Waltomatic,

I'am from MG... hehe

MES found only

Engine IAW7GF, with invalid ISO code
Selespeed CFC319
Body Computer Marelli (2)
Instrument Panel Marelli

ABS and Airbag modules are not listed.

hmmm, I think that booth need VagCom/KKL interface, it don't read too?