Multiecuscan

Hello Yani,
Is there posibility to add this function for PROXI Aligment on Punto II?

Reading CAN configuration data ...
CAN CONFIGURATION DATA:
00 00 00 2F 00 00 00 0F 00 00 00 00 00 00 00 00
00 00 00 2F 00 00 00 09 00 00 00 0F 00 00 00 09 00 00 00 09
34 36 37 36 38 39 39 39 20 20 20 44 54 53 49 45 45 50 44 45 20 20 01 01 12 2F 00 00 00 09 00 00 00 0F 06 10 03 06 0C 15 07 00
CURRENTLY CONFIGURED CAN MODULES:
Body Computer Node (NBC)
Engine Control Node (NCM)
Electric Steering Node (NGE)
Dashboard Node (NQS)
Receiver Radio/Radio Navigator Node (NRR/RMN)
CURRENTLY AVAILABLE CAN MODULES:
Body Computer Node (NBC)
Engine Control Node (NCM)
Electric Steering Node (NGE)
Dashboard Node (NQS)
REMOVED CAN MODULES:
Receiver Radio/Radio Navigator Node (NRR/RMN)
CAN MODULES THAT REQUIRE EOL PROGRAMMING:
Body Computer Node (NBC)
Dashboard Node (NQS)
2014-05-11 19:47:26
CONNECTED TO:
Fiat Punto '99 1.9 JTD
CAN Setup / PROXI Alignment Procedure
--------------------------------------------------------------

CURRENTLY CONFIGURED CAN MODULES::
Body Computer Node (NBC):
Engine Control Node (NCM):
Electric Steering Node (NGE):
Dashboard Node (NQS):
Receiver Radio/Radio Navigator Node (NRR/RMN):
:
CURRENTLY AVAILABLE CAN MODULES::
Body Computer Node (NBC):
Engine Control Node (NCM):
Electric Steering Node (NGE):
Dashboard Node (NQS):
:
REMOVED CAN MODULES::
Receiver Radio/Radio Navigator Node (NRR/RMN):
:
CAN MODULES THAT REQUIRE EOL PROGRAMMING::
Body Computer Node (NBC):
Dashboard Node (NQS):

EXECUTING ADJUSTMENT...
PROXI ALIGNMENT PROCEDURE
Writing CAN configuration data ...
Writing to module: Body Computer Node (NBC) SUCCESS!
Writing to module: Dashboard Node (NQS)