Multiecuscan

Hi i have been trying to reset my airbag light on my 8V MK2 Punto 51 Plate. I have purchased this cable : http://www.ebay.co.uk/itm/1711753215...84.m1439.l2649

And these adapters : http://www.ebay.co.uk/itm/MultiECUSc...item2a3bc4f469

When i connect to MultiEcuScan It doesnt allow me to connect to my airbag. I have tried all 3 airbags that are available for my car but it wont connect to any of them.

I have included pictures of my cable setup and port settings. Ive also included a picture of the message i recieve.

I did test the interface when i connected the cable and it all seemed to be ok. But just couldnt connect to anything.

Please Help

Hello

Install this driver

http://www.ftdichip.com/Drivers/VCP.htm

Then check the settings and press the test button once
in MES / Settings / Interfaces / Test

What is displayed?


Greetings Eddy