Multiecuscan

hi
ihave an alfa 147 selespped 2006 i can make nearly all the adjustment without any problem,
cluch drain.....ok
accumulator dessprezuration....after unplug pump and reconnect the software to the car...ok (if not wont work)
production/service final calibration...after reconect the pump and restart multiecuscan and reconnected to the car....ok
actuator base adjustament....ok
engagement lever pin securing screw diagnosis....ok
selection lever return diagnosis....ok
cluch self calibration enable....i try everything and after one second to execute the software tell me that is ???correct??? i can`t even start the car and put 2nd gear!!! if somebody can do it please explainme step by step...
regards

Same proble for me!
Grande Punto 1.3mjet dualogic.
i have mes 1.8 end cantiecar interface.

Foun the solution.....
You has To execute it, and has To tell you that is corrrect....in That moment the car will start To learn the cluch position...so you will has To do all the steps....switch of...con again....second gear....and 3000 rev and stop....i dont remind the name but if you check the cluch separation has been change....

Hello

The Selespeed clutch is set as follows!

- Warm up the engine> 80 ° C
- Clutch should be warm between 20 ° C and 150 ° C.
- Connect and connect MES.
- 2, in gear
- Press "Enable self-adjustment clutch"
- Starting in the second Drive gear and with approximately 3000 U / min relatively evenly
- Finished


Greetings Eddy

This solution is also valid for the grandepunto?

Hello fiatuno

So far as I know this is for all Selespeed as required

Greetings Eddy

Unfortunately in my case the procedure described in "mes" does not work.
1 Connect interface and start the program with the key in "mar" and the engine off.
2 start the procedure to be "mes".
3 start the engine.
But at this moment the "gear" goes into neutral without giving me chance.
And it remains so until the end of the procedure.
How come I can not do the 300 meters in 1st gear?
Tanks.

My gear is cfc300 6 speed on grandepunto 1.3mjet 90cv 2009.

Hello Fiatuno

Do you have the Start & Stop function disabled?


Greetings Eddy

Hi Eddy,
my car not have Start & Stop.