Multiecuscan

Hello!

I'm trying to reset the Oil replacement indicator with the registered version of Multiecuscan I bought a few hours ago...

I'm using an ELM327 officially ver 1.4. I can connect it and see all the parameters displayed with no problem.

When I try to reset the oil degradation indicator, multiecuscan tells me that the modification goes well, and I got no error. But when I start the engine, the oil light continues to blink as it was doing before, and the parameters displayed in multiecuscan (oil degradation) stays the same...

I don't know what to do to deal with this issue....

Can you help me?

In general Oil resetting is done in engine ECU and service interval ECU.
Until you reset both service messages in engine ECU and service interval you will have that problem.