Multiecuscan

Hi,
my mother has a 2001 Fiat Palio 1.9 TD or JTD (don`t know exactly) and she has some Problems with the Airbagsystem. The Car has a 3Pin Connector for the Motor ECU. After a look at the supported Vehicles, i think i need such a Interface Adapter http://www.ebay.de/itm/151016677380?ssP ... 1439.l2649 . Is that right and will that works?.

Thank you for your response

Wheely

Post new link or photo from the interface.
Link from above does not work...

Hi,
the Link works for me . This is the Ebay Item Nr. 151016677380

http://www.ebay.de/itm/151016677380?ru= ... 26_rdc%3D1

Wheely

OK! I can see link now. Yes this package is OK.
In general for your Fiat Palio you need KKL interface (or VAG 409.1 how it is called) and 3 pin adaptor.
You do not need additional adaptors: A1, A2 and A3. If you do plan to use it on other Italian cars than other 3 adaptors (A1, A2 and A3) will be helpful.

Hello

How alfa156sarajewo already wrote!
It is only the switchable KKL interface and the 3 pin adapter needed.
The adapter (green, red, yellow) are not required.

I have to write why he Sold this package as the seller of times?


Greetings Eddy

Hi,
thank you for your reply`s. I have order it and can`t wait to test it. I hope i can read the fault codes of the airbag system.

Wheely

Hi,
today the interface arrived. I have one Question. I must only use the 3Pin Adapter Cable and which switch must i select on the Interface?. When i want to connect to the Airbagsystem, i must use switch Nr. 3 (called Airbag), right?.
But on the supported Vehicle List is a information that called : "PLEASE NOTE: For the old (non-EOBD) vehicles with 3-pin diagnostic connector you need UNMODIFIED interface with 3-pin adapter.". What means unmodifified interface?, are that interfaces without switches and so i can`t use this interface that i bought?.

Wheely

Hello

Alfa156sarajevo and I had already written it
Is a switchable KKL interface for vehicles need the a 3 pin adapter not required.

On your link I wrote that the offer with the switchable KKL with 3 adapters (green, red, yellow) makes no sense.

When using a 3 pin adapter, the KKL interface has switchable on
the No. 7 position stand.

Since you use to access through transfer it to the controller in question.
Thus, a changeover switch is not necessary.


Greetings Eddy

When you have VAG cable with a mini switch on it, and you want to use 3 pin adapter for some other cars, please set the VAG interface on pin 7 (engine) - and do not move it.
So you set mini switch on pin 7 of your VAG interface, connect your 3 pin adapter on it, and than you can use it like that for all systems like abs and airbag (for older cars which have only that 3 pin connector).
No need to move switch on VAG interface. No need to set it on pin 3 or pin 1 on your VAG interface.
Just keep it fixed on pin 7 of VAG interface when you using 3 pin adapter.

Hi,
i did it and everythink was fine. I could connect to all three ECU (ABS,Airbag and Motor). So i could delete the faultcode of the Airbag (low power supply).
Thanks for you advise.

Wheely