Multiecuscan

Can anyone help, have reset the service and coupons but I cannot get the oil change light off. On multiscan it says to connect to the ecu. How do I do this as I only have OBD connectors so I have no idea on how to do this or what cables I would need as the 2 sockets on the ecu are very different to anything I have.

Regards

Scott

Hello Scott

Connect your Mito with the motor control (EDC16. ...) and press
F7 settings in the first field there is the button "oil change"
press this then should the pilot light go out.


Greetings Eddy