Multiecuscan

hello

after scanning for available modules on my above mentionned alfa, I got the following informations:
Bosch Motronic ME 3.1 EOBD (3.0 V6) with
ISO 7C 86 13 80 EA

but when I choose the available Bosch Motronic ...^^ within the software UI I got an error saying: wrong ISO

checking the information tab it states
ISO FD 86 15 01 6E

any suggestions to solve the problem?

I got the same error on both the KKL and ELM interfaces.

After you got wrong ISO code message just click Y and do go to read parameters and errors.
It means your ECU is not supported yet, but we hope Yani will add it in next release.