Multiecuscan

I have a fiat linea 1.4 t-jet engine
i can't access the car at all Can info
and when i scan the car it shows engine only!!!
if i bought a full version will be my car fully suported ?

Hello

We Linea at your motor control, ABS read more about the protocol KWP2000. For the ABS you need an adapter 1 (green)

The other controls are read via CAN bus, plus you need an ELM interface!
Do you use an ELM?

With the free version Multiecuscan should at least be found all controls.

If so, then read times on here

viewtopic.php?f=5&t=1493

Greetings Eddy

yes i am using an ELM
it is probably the resistor problem

Hello Yoko

If the bridge resistor is the problem, you have enough information that can help you in the linked post.

Greetings Eddy