Multiecuscan

i am trying to connect using KLL/VAGCOM cable and the maximum i get is 2 seconds of connection to the Engine ECU, then it disconnect!
when i run the test, it gives me a message saying "system support high resolution" anyone can help me with what does this mean?
i have an Alfa 147 1.6 TS

many thanks in Advance

Hello

Which version of MES / FES do you use?
Have you asked the Latency Time in 1?

Otherwise, try to use
MES / settings / interface /
and make a check mark in "high latency mode"

Greetings Eddy

Hi,

Thanks for your reply, as for the version its the latest, "have been just downloaded few days ago" as for the settings i also tried as you advised and still no luck!

Thanks alot,

Best Regards,
Amr