cant connect to ecu punto
Posted: 31 Mar 2013, 19:26
Hi, You have probably heard it all before but here I go. I am trying to connect to ECU on Punto 03 1.2 8v. I have Multiecuscan free version 1.3 loaded onto laptop running win7 32bit. Com port drivers are the latest (2.08.24)and I am using a vagkkl cable I got from ebay (see link at bottom of post)
I have set up com port as per instructions including latency timer set to 1, i have settings as per instructions. interface test is good with results identical to screenshot. Scan for interface detects the interface ok. Its only when I try to connect to the ECU the the problem occurs. "Unable to detect ECU check cable and com settings"
I have tried using another laptop running Vista, again fresh download of MES and com port drivers
Everthing tests ok but when I try to connect to ECU the same problem as detailed above.
Any suggestions welcome
http://www.ebay.co.uk/itm/VAG-KKL-409-U ... 1364773%26
I have set up com port as per instructions including latency timer set to 1, i have settings as per instructions. interface test is good with results identical to screenshot. Scan for interface detects the interface ok. Its only when I try to connect to the ECU the the problem occurs. "Unable to detect ECU check cable and com settings"
I have tried using another laptop running Vista, again fresh download of MES and com port drivers
Everthing tests ok but when I try to connect to ECU the same problem as detailed above.
Any suggestions welcome
http://www.ebay.co.uk/itm/VAG-KKL-409-U ... 1364773%26