Multiecuscan

Hi! I have multiecuscan 1.3 registered and an elm327 with adapter 3. I would like to know if it is possibile to activate the cruise control on an alfa Romeo mito 1.6 jtdm 120cv year 2008. Thanks so much.

Hello mpaocetul

Have you installed a cruise control later?

The key function in the body computer you can check parameters
Power Button
Set +
Set -

Otherwise, a proxy alignment (Can setup) should also be able to assist.

Greetings Eddy

Hi! Yes i ha ve installed a cruise control aftermarket! I don't understand what you told me because i ma italian can you explain in simpler words? excuse me and thanks again. PS. I know that there are tip up tip down and rest button but i haven't understood the other parte if tour message

Ciao

Impostare un link per la configurazione del controller CAN fa
andare alle impostazioni (F7) e provare un
Proxi Alignment


Ma se non c'è il cruise control originale, questo è probabilmente non aiuta

Saluti Eddy

google translate

If i have understood i have to center in can setup band activate cruise control. Then do the proxy allignement. Right? I know the procedure but i asked if multiecuscan can do if. If mito si supported.
Thanks

Hi

Its an original Cruise Control ???



Greetings Eddy

Yes sure! Original but installed aftermarket

Hi

Then test it for the Proxi Aligment


Greetings Eddy

Who can explain me the self-learning function of multiecuscan?

Hello

You mean the self-learning function for the interface?

This is usually automatically

- Interface in USB plug
- Installing drivers
- Interface in OBD connector plug
- Multiecuscan start
- MES / Settings / Interface / scan interface


But will still be set manually the Latency Time to 1

Greetings Eddy