Page 1 of 1
reset self adaptive Parameter - Montronic M2.10.4
Posted: 19 Mar 2013, 19:30
by unforgiven
is it possible to reset the self adaptive parameters in MES with a Bosch Montronic M2.10.4?
i did not find the option yet ...
Re: reset self adaptive Parameter - Montronic M2.10.4
Posted: 21 Mar 2013, 20:41
by alfa156sarajevo
As far as I know reset of self adaptive parameters on Bosch Montronic M2.10.4 with MES is not possible.
Since this is older ECU it hard find diagnostic equipment that can do it…
You can try it with battery off, wait for 45-60 min, and then driving car a little bit slowly and little bit faster.
I am sure somewhere on this forum or some other forum you can find that detail info how to do it.
I tested on petrol cars and on most of them did work.
I also tried on diesel cars but it does not work on them...
