Multiecuscan

good evening;
I have bought a vagkkl cable but cannot connect to the ecu scan. 'Ve had quite a few forums gone off, but nowhere to find an answer. Therefore this post.
I have done the necessary settings (see screenshots). But everytime I get the message "no eco response" who CAN HELP ME

Hello

In your first screen you clicked your ABS and not your ECU
For your ABS you need a switchable KKL or an adapter plug green

For the ECU are no adapter needed

Have you in Multiecuscan / settings indicated a KKL and the correct COM port?


Greetings Eddy

Hello, thank you for you answer.I have purchased this cable and there are 4 things that I can read, airbag, engine, etc. the cable is on position 1 during the screenshots. Greetings

Hello

Ah, OK
With the switchable KKL you need no adapter cable, properly

Charging you this driver for your interface

http://www.ftdichip.com/Drivers/VCP.htm

And check the settings in Multiecuscan as I wrote
then it should work

Greetings Eddy

I have checked everything again, and now this is the error message (see screenshot) also have another version . put out a test done on the cable (which is also good) .... But still no connection

Hello

You still used Fiatecuscan 3.4.1??
this version is very old!

And if I remember correctly this version had severe problems with the KKL connection

Charging you the new version of Multecuscan and try it again

Und die Sprache in dem Fenster kann ich nicht übersetzen

Or is not this version correctly

Greetings Eddy

I have the latest version picked up at this site. But still he gives that I get no connection. Have also read the manual but there is something in of 10400 bps. That I only get in dos. But not in the com port settings of device manager. greets and thx

who can help me...... plaese

sergio_c wrote:who can help me...... plaese

probably someone who is close to your place and who has patience to test it or somebody via teamwiewer...