Multiecuscan

Hi there i have a alfa 147 and just put a new pioneer x8500xdab head unit in and now i can not do a proxi alignment procedure as it keeps failing on dash NQS node. It just says timed out can some one help me out please

Hello

I think you need a CAN bus adapter, of your new Pioneer x8500
The body computer is missing, and therefore stops the teaching (Proxi Aligment)

I think this is such an adapter

http://www.ebay.de/itm/ALFA-ROMEO-147-G ... 2eb7e4cc99

Greetings Eddy

Hi there and thanks for the reply. But it sees The body computer and it worked fine on my over pioneer unit

Hello

Hmmm .. ?! OK

So you have no errors in the display?

Then I would make my first time not worry about terminating proxy setting


Greetings Eddy

But i think thats why my battery is going flat as it's not turning the power off right

Hi,

I changed my instrument panel in my ALFA147 1.6, but now I have ASR error and my tempomat not workable. If I will buy multiecuscan, the proxy alignment feature can help me to syncronize nods/remove error? The second problem is flashing odometer and an incorrect km value...

Thanks
bope

Yes if you get the paid version that should fix that for you

Hi,

thanks for the reply. I just forget to notice, that my car don't have ASR...so this is not just a "simple" error like airbag or MIL... can proxy alignment do the trick in this case too?
thanks

Had a similar case... After replacing old dash with newer one, ASR lamp always did stayed on + on the display I could see the message "ASR faliure".
Did a PROXY did not had any luck.

Also keep in mind that on most petrol cars function of enabling cruise controle (tempomat) is not available...
Did not check new version of MES but older on did not had that option...

Thanks for the reply! So I can forget the proxy alignment...in this case for what can I use proxy alignment?or is just an error in application(Multiecuscan)? maybe any other solution to fix it????

about tempomat: before my tempomat was workable, I think only ASR error tilt it