Multiecuscan

Hello.

I'm after some software that will enable me to re-set the actuators on my Dual-logic to enable me to bleed the hydraulic system of air after the system has been fully drained.

I've been advised that this is something that Fiat will do for £70+VAT, so was wondering if any software on this site, or that anyone has would enable me to do this?

Many thanks.

Jon.

Hi,

Your car has Selespeed CFC228F. It is not supported by Multiecuscan yet. It will be supported in the future.

Yani

Many thanks.

How soon into the future is it likly to be?

Jon.

MEP wrote:Many thanks.

How soon into the future is it likly to be?

Jon.

I will probably do it sometime in the next 2-3 months. I cannot tell exactly when.

Yani

Will the "Bosch Motronic MA1.7.3" be supported then ??