Multiecuscan

Hi to everyone!
I'm not able to have the xenon lights (Valeo) calibrated with multiecuscan. Is there anyone who is able to do it?
Is there a bug in the program?
Thank you.

The program says that the calibration failed.

Which interface did you used to calibrate xenon lights (KKL or ELM)?

Hi. I used the ELM. I can see all the parameters but when I go to calibration it is written that there is no calibration and the sensors are out of range. When I try to calibrate it says that I cannot do it..

No one?

Do you have any errors in the control module?
Also, did you check the MIN/MAX calibration position and the actual position of the front/rear sensors?

Hi,
The only thing I can tell you is that calibration is not possible.
I can use everything else with multiecuscan. Everything else is working.
How do I check the MIN/MAX calibration position and the actual position of the sensors?
Thank you.

The same problem on my 159. Not possible to do the calibration.

Who knows why....
Yani?

Anyone?
I still have the problem. It would be nice if someone could explain me how to solve the problem.