Multiecuscan

hallo,

I have a question.

Will this work on the doblo 1.3 Multijet?

I want to reset the airbag, oil, ...(warning) lights on the dashboard.
I searched around on this forum and found that there is a trick to modify a VagCom KKL cable:


The proper connections are:
pin 1 - ABS
pin 3 - Airbag
pin 7 - Engine/Gearbox
pin 9 - EPS

Here is what I can suggest for the cable:
1.Get a stock VagCom cable.
2.Then cut the connection between k-line and pin 7.
3.Then solder a micro switch to switch either k-3 or k-1-7-9. Where k is the k-line from the circuit board and 1,3,7,9 are the pins on the OBD connector.

But I need to know will this work on a Doblo 1.3 Multijet ???

If someone knows this, please tell me.

It would depend on what series doblo you have.
What's the first half of your chassis number?

the first half of the chassis number : ZFA2230000

Fiat Doblo 1.3 Multijet from the year 2009.

According to http://www.multiecuscan.net/SupportedVehiclesList.aspx
your car is marked like this in FES software: FIAT - DOBLO' (TYPE 223) CARGO - 1.3 MJET 16V.
KKL 409.1 interface should be just fine for checking the:
#1 – engine: you do not need to modification – just plug in the KKL interface to OBD connector;
#2 – airbag: you need switch between pin 7 and pin 3;
#3 – abs: you need switch between pin 7 and pin 1.

To check other modules/ systems you need and ELM 327 or OBD KEY or CANtieCAR.