Multiecuscan

Hello,
I own a 97 Bravo.
The SRS light is on, i accidently disrupted the passangers airbag.

I have FES 3.4.2 regestered.

It does not communicate to the SRS ECU. (3-pin)
The part number is 464793640

Can anyone verify that FES actually works with the ECU??

Yani, can you help please??

We actually tested it on Marea and Alfa 156... but it is the same on Bravo.
Does your car have both K and L lines on the 3-pin connector? You can try to connect them in reverse. You can also try to connect the K line (pin 7 of the interface) to both K and L lines of the 3-pin connector on the car (The L line is not working properly on some VAGCOM interfaces).
Aslo, please send me a report after trying to connect.

Hi Yani,
Thanks for the reply,
The Bravo has the 3 pin plug behind the glovebox.
It only has two wires, they are:
Pin 1- N/A
Pin 2- Blue/White
Pin 3- White/Red

The Blue/White goes to Pin 8 of the SRS ECU. This is grounded inside ECU
The White/Red goes to Pin 9 of the SRS ECU, this is the communication line.

I have tried on Examiner and it works fine, so FES definatly has problem with these older ECU

Thanks Yani

Ok...
Another question:
What is the chip of the interface? This airbag requires serial speed of 1200bps which may not be supported properly of the interface.

Hi Yani,
Thanks for the reply,

The main chip inside the KKL is a
FTDI
1103-B
C1600501
FT232RL


Thanks!

Yani? is this interface ok ?

What should i do?

Can you send me a report?

Hi Yani,
I have sent you several reports, i played around with the interface speed settings, but it made no difference.

Also, i notice that you dont support the alarm/remote central locking on this car? Why is this?

Thanks!

did you recieve the reports?

Any luck?

yes, I'm preparing a new update that will hopefully resolve the problem...