Multiecuscan

Hí people ,

My ELM 327 is 1.3a , but between pins 6 and 14 the resistance is 40 OHMs , some problem with this ?

Which is the resistance good for CAN protocol ?

Thanks.

jony wrote:Hí people ,

My ELM 327 is 1.3a , but between pins 6 and 14 the resistance is 40 OHMs , some problem with this ?

Which is the resistance good for CAN protocol ?

Thanks.

viewtopic.php?f=5&t=1493

Hello

How about you?

If a resistance of 40 ohms installed between 6 + 14?
or have you measured this resistance?

greeting

Hí mate,

I measured the resistance with a multimeter between pin 6 and 14 of ELM327.

People say it must have, around 100 Ohms , this is a good interface .

Hello

I do not know where you got this information?

The resistance must be very high between Pin 6 +14
so that no signal is connected between the high and low.

I knew the values ​​and have not measured my ELM

The resistance between pins 6 + 14 >47 kOhm
no 40 or 100 ohms

The ELM 1.3a should have no problems in the CAN bus.
Be removed at this ELM has nothing to solder or

Greetings Eddy