Multiecuscan

Hi,

i had reset my Self-Adaption on IAW59F / HW 604 with FES 3.3. My car is an Fiat Seicento 1.1 MPI Year 2001.
The MIL is flashing now and i can't turn it off!

I had tried this from the manual:

1) warm up the engine
2) increase the engine speed three times to 4500RPM and keep it for 3 seconds each time.

after done this, the MIL is flashing again. Any help out there?

greets Dennis

Do you get any errors later when you connect car with the FES?

For Self-Adaption test you should do next:
1. start car
2. worm up the engine (minimum 75C° - I would recommend 85C°)
3. turn off the car
4. turn ignition on (MAR position)
5. execute procedure
6. start the car
7. increase the engine speed 3 times above 4500rpm (I would recommend 5-6000 rpm) and keep it for 2 seconds each time.
8. after that MIL light is turned off
9. turn of the car