Page 1 of 1

Lancia LYBRA 2,4 JTD Connection

Posted: 15 Jan 2010, 12:30
by zbebus
Hello
I have BOSCH EDC15C7.
Today i connected my LYBRA to multiecuscan.
all works fine, but i have some question.
On tab parameters - Fuel temperature, Multiecuscan showed me 3,1 , outside temperature is -4 degrees.
but air sensor temperature Multiecuscan showed me 5 degrees.
this is error? how I have this to read?
greatings
Zbynio

Re: Lancia LYBRA 2,4 JTD Connection

Posted: 30 Jan 2010, 00:15
by skinnerpl
Siema Zbynio
Can U say me Your settings for the usb/vag-com cable? // Mozesz mi powiedziec jakie masz ustawienia kabla usb vag/com?
I can't connect witch my Lybra // Wiesz
I have 2x Lancia Kappa but one is 2,4 JTD (EDC15) and 2.0 20V VIS (M2.10.3).
For JTD i cant connect to all systems (abs/airbag/engine), and to my m2.10.3 i try connect to airbag, because we dont have softrware to the engine. And nothing.
I'm supposed i have wrong configuration of my usb vag-com. Can You wrote me Your settings this port? You use standard com rs232 or simulate rs232 from usb? // Nie moge sie polaczyc z zadnym z samochodow Lancia, przypuszczam ze mam zla konfiguracje kabla usb vag-com. Mozesz mi napisac swoje ustawienia portu? Uzywasz kabla na rs232 czy kabla usb?

best regards
skinnerpl // bartek
pozdrawiam