Multiecuscan

hI

I downloaded today latest version and tried to debug my Alfa 156 2005 JTD.
It readed fault codes fine but when reading parameters, outside air temp were -201C and battery voltage 3V and so on.
I used some Vag K+CAN cable I was able to find which works fine with VAG cars.
Multiecuscan blaimed something about ISO type when connected but was able to communicate.

What could be the cause?

I will buy right away the official commercial version of this nice software when I know that it works !
This fault code stuff saved me just several hundred euros and huge waiting to the brand service point.

Thanks,

JJ from Finland

mrjj wrote:Multiecuscan blaimed something about ISO type when connected but was able to communicate.

This is exactly the cause.
Invalid ISO Code means that the ECU which you selected in Multiecuscan is not the same as in the car.