Multiecuscan

Hello Yani and all.....
I have a problem with "FES" 3.2(registered) and Dash 147 jtd year 2002.
With FES 3.2 and ELM327 1.4 (without resistance) I can not log in diagnosis in the dash, but I can enter in all CAN devices.
I can enter in service function, but but I get the message: "ISO code wrong"
I can get in diagnosis in my dash, with another program, that gives me this data:


Tested device: Instrument panel Mannesman VDO
___________________
DEVICE INFO:
Fiat drawing number: 735290191
Hardware number: C6
Hardware version: 00
Software number: ALFA 937 HL
Software version: 0276
Homologation number:
ISO code: 3283898013
Programming date: 11/07/2000


Why can not I go with FES?
P.S: I can not do, the proxy alignment on my dash, because it gives me: timeout error

Thanks

The Instrument Cluster module of alfa 147 is not supported yet.
The message "Invalid ISO code" for the service reset function is a bug in Multiecuscan 3.2. You can simply ignore this message and continue.

Hello Yani.
I so can not do the alignment proxy, because it gives me timeout error on the DASH. How can I do?
Why I can not make the diagnosis on the DASH?
thanks