Multiecuscan

Not sure if I've missed something obvious, but I can't seem to find a way to print any reports, error code lists etc
Is this supported, and I'm just having a blond day?

If not, can this be added? Having a record of the fault codes, and parameters is critical to us.

many thanks, keep up the great work

Richard

Good point.

Meanwhile you could bypass that editing the log file.
It shouldn't take more than few minutes.

fiorano wrote:Not sure if I've missed something obvious, but I can't seem to find a way to print any reports, error code lists etc
Is this supported, and I'm just having a blond day?

If not, can this be added? Having a record of the fault codes, and parameters is critical to us.

many thanks, keep up the great work

Richard

If you have registered version of FES software just go to folder where you have all saved reports and just click "Ctrl + P" buttons on keyboard and that is it!
That is how am I doing it!

See photo!