Multiecuscan

Hi there,

Recently bought some dials for my fiat punto mk2 1.2 8v,

Multiecuscan says i can do the proxy align yet when i try with the free version it only simulates it.

Anyway i can use this feature without paying? Seems a bit daft to pay like £50 to use one feature once.

Any help or suggestions would be very grateful. Willing to pay a small fee just to use the one feature.

On the Supported Vehicles List, the "CAN Setup / PROXI Alignment Procedure" is listed in red type for the Punto, which means it's only available with the registered version of the software.

You say it's daft to spend £50 to use the feature once.
It's perhaps not as daft as paying for an hour's labour (probably £70+) for the dealers to do it for you. Particularly since if you buy the package, you can do it again as many times as you like.

It always amazes me that people have the nerve to complain about missing features in the FREE version of a software package!

Juggers2k wrote:...
It always amazes me that people have the nerve to complain about missing features in the FREE version of a software package!

I agree with you!

How is it possible to question the price of registered version compared with one labor hour in FIAT dealer.
I am a proudly user of FES registered.

Regards,
Alfiat