Page 1 of 1

Problems with Ducato 3,0 DPF Service Reset

Posted: 18 Aug 2011, 10:54
by jantimralf
Car: FIAT Ducato 3,0JTD 2008 with Diesel Particular Filter (DPF)

The important function for me is the Service Reset and the Service Reset for Oil Change.
This function is new in version 3.2 and so I was happy to use it, but it want not work at first.
The problem was, that I got the failure notice “False ISO Code” when I use the function.
But I can ignore that and then I can change the the most values. So also the values for normal Service Reset.
The problem is futhermore that the oil lamp is blinking after starting the motor and the display shows: Oil Change.
Now I found, that this is a special problem of my car with the Diesel Particular Filter (DPF). There must be a special reset and this is not included at the moment in Version 3.2.
Now I found the solution:
The reset of the oil change warning for my Ducato 3.0 with DPF can be made with the selection Fiat Croma ’05 2.4 MJET 20V. You must ignore the notice “False ISO Code”. Then must be selected: Engine. After pressing F7 there is the first point the reset of Oil change for DPF cars. :D

Re: Problems with Ducato 3,0 DPF Service Reset

Posted: 25 Aug 2011, 09:27
by Knaus
Thank you for this! It is a great help!!!
Finely I´ll get the Reset with this program. :D :D

Re: Problems with Ducato 3,0 DPF Service Reset

Posted: 12 Aug 2012, 12:51
by Gégé27
Hello,

I installed the update to know Multiecuscan 1.0.
I have a FIAT Ducato 3.0 JTD- no DPF
as well as interface ELM 327 and of the 3 cables adapters.

Engine = OK
Airbag = OK
ABS = OK
Power-assisted steering = OK
Structure = OK

Service interval reset = invalid Iso code : To support on Y to continue or NR to cancel

Air-conditioning = impossible to reach it even with cable 3