Multiecuscan

Hi, i just have order the new multiecuscan. I am new in this forum, write from spain, i wonder that we can buy one of the best diagnosis system to a fiat/alfa/lancia. Thanks for the author.

Yesterday i was testing to make the proxi alignment in fiat stilo 1.9 8v 120cv year 2007 to add the cruise control lamp in an aftermarket instalation.

¿Have anybody tested this car, i try with fiat stilo 1.9 8 and 16v, and dont connect.

I tested with elm327 1.4 device in my alfa gt and i can add the original navi+ in the proxi alignment procedure.

I test too with fiat stio 1.9 jtd 115cv year 2003 and it works fine.

I think the problem is in that car in concrete.

Thank you very much

Nobody has the same problem?

ervirux wrote:Nobody has the same problem?

I and couple other people have the same problem. Simply multiecuscan don't support Fiat Stilo Multijets (mine is 2006). As far as I know all fuctions but proxy alligment do work.

I would gldly pay 50 euros just for beeing able to do proxy alligment on my Fiat.

What error do you get when trying to connect to PROXI Alignment?

Hello
I have same problem. Stilo JTD mjet 8v, 2007 and FES 3.3
All other ECUs over ELM interface work perfect, but only PROXI Alignment, not!
Error message: Connection failed, check your cable etc...
Any solution?
thx