Multiecuscan

Hello,

Escuser my English, but I am French. Here is when I want to connect in the ABS and in the Airbag of my 147 JTD 16, the message " Connect adapter1 / Green (now pin1) "and" connect adapter2 / red (now pin3) ". I do not understand this message. Which he(it) could help me. Thank you in advance.

You need to remove the relevant controls to read the designated adapter
access to the pins to read about these controllers.
With a standard interface from the trade you can read no ABS or airbag.

In the list of supported adapters Occupancy Vehicle control is
shown.
Look at the times, and you understand what is required

Greetings Eddy

Or is the list of supported adapters?

Thank you Eddie

To the right of the vehicles on the side of Supported Vehicles are Adapter
shown. There you can see how and why the adapters are required.

Greetings Eddy