While connecting to ecu i can't abort
Posted: 18 May 2011, 17:38
Hi,
It's from a long time I'm seeing this bug..
If something goes wrong while connecting, FES goes into an infinite loop and there is no way to go back....i have to kill the application. (and right now it's frustrating because everytime it happens i have to wait 4minutes to get fes working...)
Yesterday happened once and I'll explain the situation:
I forgot to turn on the dashboard and i was trying to connect to engine ecu..
So, just started FES and pressed F10 to connect..."comunication error" bla bla bla
I tried again and again I got error (of course), so i just thought the com port was changed <-- (damn me
)
I changed the com port on FES Settings and....SURPRISE.....the pop up went in a infinite loop saying "connecting....." - "press ESC to abort" but nothing happens if a press esc!!
I clearly remember it used to happen in the past...and unfortunatly not in few times; i think even before version 2.x...
does it happen only to me?
It's from a long time I'm seeing this bug..
If something goes wrong while connecting, FES goes into an infinite loop and there is no way to go back....i have to kill the application. (and right now it's frustrating because everytime it happens i have to wait 4minutes to get fes working...)
Yesterday happened once and I'll explain the situation:
I forgot to turn on the dashboard and i was trying to connect to engine ecu..
So, just started FES and pressed F10 to connect..."comunication error" bla bla bla
I tried again and again I got error (of course), so i just thought the com port was changed <-- (damn me
)I changed the com port on FES Settings and....SURPRISE.....the pop up went in a infinite loop saying "connecting....." - "press ESC to abort" but nothing happens if a press esc!!
I clearly remember it used to happen in the past...and unfortunatly not in few times; i think even before version 2.x...
does it happen only to me?