Multiecuscan

Buon giorno a tutti, ieri ho comprato multiecuscan 2.8.2 e tramite ELM 327 sono riuscito ad entrare in centralina motore per spegnere la spia dell'olio in quanto ho cambioto l'olio.
Quando ho riacceso il quadro peò la spia continuava a lampeggiare.

Come posso fare?

Grazie a tutti.

Good morning everyone, yesterday I bought multiecuscan 2.8.2 by ELM and 327 are able to enter the engine control unit to turn off the lamp oil because I changed the oil.
When I powered on the part ment the light was still flashing.

How can I do?

Thank you all.

Did the "Oil Change" procedure completed with SUCCESS or FAILED?

Did you also reset the service interval?

The oil reset procedure is successful.
I also reset the service interval.
When I turn off and turn on the oil light starts to flash.

Your vehicle has the DPF, so you have to go in parameters of engine ecu and make the "oil change dpf reset" procedure.

Thanks dallas I do that procedure, the system tells me that the procedure was completed, but when I turn off and turn on the context, the oil light starts to blink again.