Multiecuscan

Support message board
https://multiecuscan.net/forum/

Fiat ECU Scan don't connect no ECU response

https://multiecuscan.net/forum/viewtopic.php?t=2154

Page 1 of 1

Fiat ECU Scan don't connect no ECU response

Posted: 09 May 2011, 11:38
by palamp
I buy a KKL Cable, connect pin 3 to pin 7 but it can not connect to the airbag ECU alfa romeo 1.8 MY 98 :?

I debug FES using arduino prototyping board it seem that the software doesn't send data to the Airbag ECU a wakeup signal why? :roll:

Re: Fiat ECU Scan don't connect no ECU response

Posted: 11 May 2011, 10:02
by ARomeo
palamp wrote:I buy a KKL Cable, connect pin 3 to pin 7 but it can not connect to the airbag ECU alfa romeo 1.8 MY 98 :?

I debug FES using arduino prototyping board it seem that the software doesn't send data to the Airbag ECU a wakeup signal why? :roll:
Do not make short circuit between pin 3 and pin 7. You have to disconnect a wire from pin 7 and connect it to pin 3
All times are UTC
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited