Page 1 of 1
Which pin interface and the xenon headlights will be read?
Posted: 02 May 2011, 21:22
by Alfaeddy
Hello
Unfortunately I can not see in the list of vehicles with which interface and which pin the xenon headlights is read.
Is needed in the list, only the adapter from A1 (green).
So I think that it is not read via the CAN bus.
Can someone help me?
Thanks and regards
Eddy
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 06:05
by yani
You need to connect to pin 12 for the Xenon module.
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 07:19
by Alfaeddy
Hi Yani
Thanks for your quick response.
It is safe to read only with a ELM interface?
Greetings
Eddy
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 07:59
by yani
Alfaeddy wrote:It is safe to read only with a ELM interface?
You can read it with any interface - KKL, ELM, OBDKey.
However, if you are using KKL (VagCom) interface you will probably have to set "KWP2000 Timings" (in Settings) to "Default".
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 08:59
by dallas140cv
In the "Supported vehicles" list, all xenon projectors interfaces is specified only as "A1", without any other type. Can you correct this, please?
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 10:38
by yani
dallas140cv wrote:In the "Supported vehicles" list, all xenon projectors interfaces is specified only as "A1", without any other type. Can you correct this, please?
Yes, I will correct it...
Re: Which pin interface and the xenon headlights will be rea
Posted: 03 May 2011, 11:28
by Alfaeddy
yani wrote:Alfaeddy wrote:It is safe to read only with a ELM interface?
You can read it with any interface - KKL, ELM, OBDKey.
However, if you are using KKL (VagCom) interface you will probably have to set "KWP2000 Timings" (in Settings) to "Default".
Thank´s for you
Greetings
Eddy