Multiecuscan

Hi friends ,

I'm from France, excuse me for my poor English lol I have a 2007 Fiat 500 1.3 MJT.
I'm working with multiecuscan 2.7 Registered version and a ELM327 interface V1.4.
All is ok, communication between interface, OBD and the soft is ok no problem.
The only problem I have is that I can't reset with the soft the "oil service" message (in french : "vidanger huile moteur") and the red light "oil pressure" is still flashing.
I'am using - as asked in the Supported Vehicle page - the adapter cable 3 for the "Service Interval Reset", communication is Ok I can read all the service parameter.
But I can't reset that message ...
Of course the oil level is Ok and there's no problem with the oil pressure.
I search on the forum about that but I didn't find anything
Any idea ? Can multiecuscan do that ?

Greetings From France, Michuts

Hi Michuts,

Yani wrote on some topic about that... but I can not find that topic...
Anyway, multiecuscan can not, at the moment, reset the "oil service" message.
It can only reset the "Service Interval Reset"!
One guy from forum have the same problem on Alfa Mito...

Actually, this function IS available for 1.3 MJT....
You have to connect to the engine and go to Adjustments. There is a function called "Oil Change". Just execute this function and it should reset the message.

Hi Alfa156sarajevo, Hi Yani

Thanks a lot for the answer. I'll try that on Saturday, i'm not actually at home.
I'll tell you if it's ok or not.

Many thanks, Michuts

hi friends

ok, but problem is on fiat 500 just elm interface work, but to scan ecu is one configuration and to scan dash, you must change configuration

i say configuration, the pin number in obd !

maybe anybody have solution to shint obd pin or made one adaptator ???