Multiecuscan

hi there, i would like to do a forced regen as my dobbie shows 74% blocked, the poblem is i have never done this before so can any one please post a step by step guide on how to carry out this procedure before it blocks totaly .I do not do enough long journeys to regen automaticaly and complete the prosess. my ecu i think is a ed16. help would be much appriciated.

sorry for the lack of information. my dobbie is a 2007 1.9 multijet engine 120 dynamic. this engine is not on fiat ecu scan the closest under the fiat heading is the 1.9 jtd doblo ed16 which does have a option for regen of a dpf or the grande punto with a 1.9 mjet. which of these is best? are regen procedures all the same for all 1.9 engine fiat carsand once i decide which to use do i just click on to the regen icon and watch it carry out the prosses automaticly or do i have to rev it myself to 40000 rpm, if so for how long? thanks again to who ever replies.(you can see why i asked for a step by step as i have not done this before but i'm sure its easy once shown how)

When connected to ECU with FiatECU then go to the ACTUATORS function. If DPF regen is supported then it should be listed here.

Is a 1.3 85ps or a 1.9? I think a 1.9, because you write that ecu is the edc 16. If yes, search another 1.9 multijet euro 4 (stilo, 147, multipla, etc) and select the edc 16 ecu, the program will connect signaling that the iso code is wrong, click ok and good job! Go to actuators and you can find the dpf regen.